Danze D461722 - Installation Manual Uživatelský manuál stáhnout pdf

• Installation Steps:

• Hardware Provided

/Petit matériel de fixation fourni/Se incluye los herrajes:

Mounting Screw/Vis de fixation/Tornillo de montaje

Plastic Anchor/Vis d'ancrage en plastique/Sujetador de plástico

Hex wrench/Clé hexagonale/Llave hexagonal

Versa™ 30" Slide Bar Assembly

Ensamblaje de ducha de mano de 30” con barra Versa™

Ensemble de douche à main de 30 po sur barre coulissante Versa

INSTALLATION

Fig 2

Fig 1

Post/

montante/

fixation

Slide bar/

Barra/

Barre coulissante

Base/Base/Base

Cap/

Tapón/Capuchon

Slide body/

Pieza deslizante/

Support coulissant

• Tools Required/Outils requis/Herramientas necesarias:

Flathead Screwdriver/Tournevis á lame plate/Destornillador chato

Phillips Screwdriver/Tournevis Phillips/Destornillador cruciforme

Marking Pencil/Marqueur/Lápiz marcador

Level/Niveau/Nivel

Drill/Perceuse/Taladro

¼” Drill Bit/Barrena de ¼”/Foret de ¼ po (0,6 cm)

This product is packaged partially assembled. You will need to take some

components apart to install.

INSTALL TOP SLIDE BAR POST

1. Remove cap. Using hex wrench (supplied), loosen set screw and

remove post from slide bar base (Fig 1).

2. Locate where you want to install the slide bar. Use the top post as a

template and mark locations on shower wall using pencil (Fig 2).

3. Using the drill bit, carefully drill four holes.

TIP: INSTALL ONE POST, THEN ASSEMBLE SLIDE BAR AND CONFIRM

HOLE POSITION OF SECOND POST BEFORE DRILLING (Fig 3).

4. Insert the plastic wall anchors into the four holes. You may need to tap

them lightly into position with a hammer (Fig 4).

5. Secure post with mounting screws provided (Fig 5).

6. Place and hold the slide bar with slide body onto the post; it should

"click" into place. Tighten the set screw with supplied hex wrench, then

press the cap (Fig 6).

NOTE: When installed correctly, the slide body will have screw holes

located on the bottom side. See Fig 6.

Repeat step 5-6 for bottom of slide bar (Fig 7).

8. Attach one hose conical to water supply outlet (not included) and the

other conical to handshower (Fig 8).

D461722

D461723

1 2 3 4

Shrnutí obsahu

Strany 1 - INSTALLATION

• Installation Steps:• Hardware Provided/Petit matériel de fixation fourni/Se incluye los herrajes:Mounting Screw/Vis de fixation/Tornillo de montajeP

Strany 2 - • Étapes d’installation:

Fig 5Fig 6Fig 4The screw holes are on bottom side.Los agujeros de los tornillos están en la parte inferior.Les trous de vis sont en dessous.Fig 3• Pa

Strany 3

Fig 7Fig 8Attach hose conical towater supply outlet(not included)/Sujete la mangueracónica a la salida dealimentación de agua(no incluida)/Fixer le fl

Strany 4 - Website: www.danze.com

Cleaning Instructions/Instrucciones para la limpieza/Directives de nettoyage• To maintain and protect the fine luster of all products, clean with a s